河北TOC分析儀廠家  產品特點

1.儀器采用便攜設計，使用輕便，方便移動至取樣點。

2.采用嵌入式系統，觸摸屏設計，純中文操作方便簡易。

3.針對制藥用水（TOC含量在1000ppb以下）總有機碳含量的檢測設計，進行檢測。

4.配備大量的儲存空間，能夠存儲大量的測試數據。

5.中文打印，輸出測試參數、測試結果。

6.在使用、貯存和更換過程中不需要氣體或試劑，無移動部件，減少維修和維護成本。

7.當測試樣品濃度超過規定限度，儀器能夠自動報警，并輸出控制信號。

8.符合國家《中國藥典》 CP2010規定的測試方案，可以提供IQ/OQ/PQ服務。

河北TOC分析儀廠家  產品特點

1.儀器采用便攜設計，使用輕便，方便移動至取樣點。

2.采用嵌入式系統，觸摸屏設計，純中文操作方便簡易。

3.針對制藥用水（TOC含量在1000ppb以下）總有機碳含量的檢測設計，進行檢測。

4.配備大量的儲存空間，能夠存儲大量的測試數據。

5.中文打印，輸出測試參數、測試結果。

6.在使用、貯存和更換過程中不需要氣體或試劑，無移動部件，減少維修和維護成本。

7.當測試樣品濃度超過規定限度，儀器能夠自動報警，并輸出控制信號。

8.符合國家2010版《中國藥典》規定的測試方案，可以提供IQ/OQ/PQ服務。

參數：

運行要求

? 交流電源：170～260 V，頻率：50/60 Hz ；

? 分析儀的量程是：電導率< 10.0 us/cm ；TOC < 1.0 PPM 。如果水樣中的無

機碳或有機碳濃度超出了儀器的檢測范圍，需使用高純水或有機碳濃度較

低的去離子水沖洗管路。

? 儀器運行的環境溫度5℃ – 40 ℃。

測試方法及其原理

國家藥典委員會發布的《中華人民共和國藥典2010 版》二部中推薦采用在線和

離線兩種測試方法，還提供了系統適應性試驗的操作方法。同時對測試總有機碳的儀

器也提出了要求，即首先要能區分無機碳和有機碳；并能排除無機碳對總有機碳的影

響；其次應滿足系統適應性試驗的要求；最后儀器應具有足夠的檢測靈敏度。

要檢測樣品中的有機物濃度，必須將有機物分子分解并且轉化成能夠測量的單

分子形式，這樣就必須把有機物氧化成二氧化碳，并對生成的二氧化碳進行測量。目

前氧化的方法有四種：一、燃燒法；二、光氧化法；三、濕法氧化；四、光化學法。

氧化后有機碳測試的方法有差減法和直接法兩種。

其中差減法的表達式為TOC=TC－IC，即總有機碳是總碳（TC）與無機碳(IC)的差值。

TA-1.0 分析儀采用的氧化方法是光氧化法：

H2O hn（185nm）‐>OH? H? OH? 有機物‐>CO2 H2O

二氧化碳的測量方式是差減法：TOC = TC－ IC

系統適應性驗證

系統適應性驗證是一種檢驗TOC 分析儀氧化能力的試驗方法，其計算公式如下：

儀器響應效率（％）＝(（rss - rw）/（rs - rw）) * 100%

其中：

rss —— 為 1-4 對苯醌對照品溶液的響應值；

rs —— 為蔗糖對照品溶液的響應值；

rw —— 為總有機碳檢測用水的空白響應值；

主要配置

主機 一臺

觸摸屏 （鑲嵌到儀器中）

微型打印機   一臺

進樣管   一條

電源線  一套

產品說明書  一份

產品合格證  一份

產品裝箱單  一份

運行要求

1交流電源：170～260 V，頻率：50/60 Hz；

2分析儀的量程是：電導率< 10.0 us/cm；TOC < 1.0 PPM。如果水樣中的無

機碳或有機碳濃度超出了儀器的檢測范圍，需使用高純水或有機碳濃度較

低的去離子水沖洗管路。

3儀器運行的環境溫度5℃ –40℃。

安全措施忠告：

1．請保證電源可靠接地；

2．電源電纜線的線徑> 2.5 mm2；

3．請勿將儀器浸泡于水或其它液體中。

 分流器

水樣進入儀器后分成相同流量的兩路，其中一路通過延遲線圈進入二氧化碳傳感器，檢測TIC，另一路通過氧化反應器利用紫外燈（UV燈）加二氧化鈦薄膜光催化氧化作用將有機物分解為二氧化碳，進入二氧化碳傳感器檢測TC?？傆袡C碳可通過這個差值計算得到：TOC = TC–TIC。

氧化反應器

儀器利用UV射線在二氧化鈦光催化劑的作用下將有機化合物氧化成二氧化碳，氧化反應器是一個UV燈外包螺旋形的石英管。UV燈發出185nm和254nm的光線，使水產生光分解。

H2O hν(185nm)（TiO2）? OH?  H?

羥基自由基（OH?）能完全把有機化合物氧化為二氧化碳。

有機物  OH?? CO2 H2O

UV燈的使用壽命為6個月，當更換時間到期時儀器將出現警告信息，提醒用戶更換UV燈。

二氧化碳測量循環

儀器每4分鐘檢測得出一個數據（包括TOC值和電導率值），在4分鐘的測量循環中TC和TIC是獨立檢測的。

Product Features

1. The instrument adopts a portable design, which is easy to use and convenient to move to the sampling point.

2. Adopting an embedded system and touch screen design, pure Chinese operation is convenient and easy.

3. Design and conduct testing for the total organic carbon content of pharmaceutical water (TOC content below 1000ppb).

4. Equipped with a large amount of storage space, capable of storing a large amount of test data.

5. Print in Chinese and output test parameters and results.

6. No gas or reagents are required during use, storage, and replacement, and there are no moving parts, reducing maintenance and repair costs.

When the concentration of the test sample exceeds the specified limit, the instrument can automatically sound an alarm and output a control signal.

8. According to the testing plan specified in the Chinese Pharmacopoeia CP2010, IQ/OQ/PQ services can be provided.

Product Features

1. The instrument adopts a portable design, which is easy to use and convenient to move to the sampling point.

2. Adopting an embedded system and touch screen design, pure Chinese operation is convenient and easy.

3. Design and conduct testing for the total organic carbon content of pharmaceutical water (TOC content below 1000ppb).

4. Equipped with a large amount of storage space, capable of storing a large amount of test data.

5. Print in Chinese and output test parameters and results.

6. No gas or reagents are required during use, storage, and replacement, and there are no moving parts, reducing maintenance and repair costs.

When the concentration of the test sample exceeds the specified limit, the instrument can automatically sound an alarm and output a control signal.

8. According to the testing plan specified in the 2010 edition of the Chinese Pharmacopoeia, IQ/OQ/PQ services can be provided.

Parameters:

Measurement range: 0.01mg/L to 1.000mg/L

2 accuracy?4%

3 Resolution 0.001mg/L

4 analysis time 40 minutes

5 response time 8 minutes

6 detection limit 0.001mg/L

Sample temperature: 1-95℃

8 Power Requirements/Function 220V

9. Repetitive error≤3%

10 color touch screen display

Operational requirements

AC power supply: 170-260 V, frequency: 50/60 Hz;

The range of the analyzer is: conductivity<10.0 us/cm; TOC < 1.0 PPM。If there is none in the water sample

The concentration of organic carbon or organic carbon exceeds the detection range of the instrument and requires the use of high-purity water or organic carbon with a lower concentration

Rinse the pipeline with low deionized water.

The ambient temperature for instrument operation is between 5℃and 40℃.

Testing methods and principles

The National Pharmacopoeia Committee recommends the use of online and offline methods in Part II of the 2010 edition of the Pharmacopoeia of the People's Republic of China

Two offline testing methods are available, and the operation method for system adaptability testing is also provided. Simultaneously testing the instrument for total organic carbon

The device also requires the ability to distinguish between inorganic carbon and organic carbon; And it can exclude the influence of inorganic carbon on total organic carbon

Sound; Secondly, it should meet the requirements of system adaptability testing; Finally, the instrument should have sufficient detection sensitivity.

To detect the concentration of organic compounds in a sample, it is necessary to decompose the organic molecules and convert them into measurable monomers

In molecular form, it is necessary to oxidize organic matter into carbon dioxide and measure the generated carbon dioxide. The eyes

There are four methods for pre oxidation: first, combustion method; 2、Photooxidation method; 3、Wet oxidation; 4、Photochemical method.

There are two methods for testing organic carbon after oxidation: differential method and direct method.

The expression for subtraction is TOC=TC-IC, which means total organic carbon is the difference between total carbon (TC) and inorganic carbon (IC).

The oxidation method used by the TA-1.0 analyzer is photooxidation:

H2O hn (185nm) ->OH? H?OH? organic compounds ->CO2 H2O

The measurement method for carbon dioxide is subtraction: TOC = TC－IC

System adaptability verification

System adaptability verification is a test method for testing the oxidation ability of TOC analyzer, and its calculation formula is as follows:

Instrument response efficiency (%)=((RSS RW)/(RS RW)) * 100%

Among them:

RSS - the response value of 1-4 benzoquinone reference solution;

Rs - the response value of sucrose reference solution;

RW represents the blank response value of water used for total organic carbon detection;

Main configuration

One host

Touch screen (embedded in the instrument)

One micro printer

One injection tube

A set of power cords

One copy of product manual

One copy of product qualification certificate

Product packing list copy

Operational requirements

1. AC power supply: 170-260 V, frequency: 50/60 Hz;

The range of the analyzer is: conductivity<10.0 us/cm; TOC < 1.0 PPM。If there is none in the water sample

The concentration of organic carbon or organic carbon exceeds the detection range of the instrument and requires the use of high-purity water or organic carbon with a lower concentration

Rinse the pipeline with low deionized water.

The operating environment temperature of the instrument ranges from 5℃to 40℃.

Safety measures advice:

1. Please ensure that the power supply is reliably grounded;

2. The diameter of the power cable is greater than 2.5 mm2;

3. Do not immerse the instrument in water or other liquids.

Diverter

After entering the instrument, the water sample is divided into two equal flow paths. One path enters the carbon dioxide sensor through a delay coil to detect TIC, while the other path uses an oxidation reactor to decompose organic matter into carbon dioxide through the photocatalytic oxidation of a titanium dioxide film using a ultraviolet lamp (UV lamp), and enters the carbon dioxide sensor to detect TC. The total organic carbon can be calculated by this difference: TOC = TC–TIC。

Oxidation reactor

The instrument uses UV rays to oxidize organic compounds into carbon dioxide under the action of titanium dioxide photocatalyst. The oxidation reactor is a spiral quartz tube wrapped around a UV lamp. The UV lamp emits light at 185nm and 254nm to decompose aquatic products.

H2O hν(185nm)（TiO2）OH? H?

Hydroxyl radicals (OH?) can completely oxidize organic compounds to carbon dioxide.

Organic compounds OH?CO2 H2O

The service life of UV lamps is 6 months. When the replacement time expires, the instrument will display a warning message to remind the user to replace the UV lamp.

Carbon dioxide measurement cycle

The instrument detects data (including TOC and conductivity values) every 4 minutes, and TC and TIC are independently detected during the 4-minute measurement cycle.